Transmission Modes in Computer Networks

Transmission mode refers to the mechanism of transferring of data between two devices connected over a network. It is also called Communication Mode. These modes direct the direction of flow of information. There are three types of transmission modes. They are:

1. Simplex Mode

2. Half duplex Mode

3. Full duplex Mode

SIMPLEX Mode

In this type of transmission mode, data can be sent only in one direction i.e. communication is unidirectional. We cannot send a message back to the sender. Unidirectional communication is done in Simplex Systems where we just need to send a command/signal, and do not expect any response back.

Examples of simplex Mode are loudspeakers, television broadcasting, television and remote, keyboard and monitor etc.

HALF DUPLEX Mode

Half-duplex data transmission means that data can be transmitted in both directions on a signal carrier, but not at the same time.

For example, on a local area network using a technology that has half-duplex transmission, one workstation can send data on the line and then immediately receive data on the line from the same direction in which data was just transmitted. Hence half-duplex transmission implies a bidirectional line (one that can carry data in both directions) but data can be sent in only one direction at a time.

Example of half duplex is a walkie- talkie in which message is sent one at a time but messages are sent in both the directions.

FULL DUPLEX Mode

In full duplex system we can send data in both the directions as it is bidirectional at the same time in other words, data can be sent in both directions simultaneously.

Example of Full Duplex is a Telephone Network in which there is communication between two persons by a telephone line, using which both can talk and listen at the same time.

In full duplex system there can be two lines one for sending the data and the other for receiving data.