Question Set 5
According to the Hess law the energy transfer is simply independent of the way being followed. If the reactant and the product of the whole process are the same then same amount of energy will be dissipated or absorbed.
Personal Statement. It is something that gives an informative background about an individual.
Bearing is a device that helps smoother movement with minimal friction which in turn helps enhances efficiency and speed. Considering two types of loading, radial and thrust, there are different types of bearings which help handle these loads. The basic difference in the types of loads is essentially due to their ability to handle weight and different kinds of loads for various applications. Different types of bearings are:
-Ball bearing
-Roller bearing
-Ball Thrust bearing
-Roller thrust bearing
-Tapered roller bearing
-Magnetic bearings
-Giant Roller Bearing
A Process Flow Diagram is a user friendly, simplified sketch which illustrates general plant streams, major equipments and key central loops and shows the relationship between major components in the system. By using symbols to identify instruments and vessels it describes the primary flow course. They also provide e detail of mass/energy balance data along with stream composition and physical properties, however do not show minor components.
Frederick Taylor was pioneer of the time and motion theory. This technique monitors the amount of time required to complete a task along with observing the steps taken by a worker to complete the given task.
Diamond is currently the hardest material, made up of carbon atoms which cannot move. Carbon is the only atom that can have four electrons in the second shell surrounding the carbon nucleus, precisely why making a diamond the hardest material. However, there also are claims by a few to a new rare material called Wurtzite Boron Nitride which has a structure similar to a diamond but has some other atoms in place of carbon.
1 BTU=1055.06 Joules
Pump is a device that is used to transfer fluid from one place to another place which means it develops flow not pressure.
A pipe is measured based on its inner diameter (ID) whereas a tube is measured based on the outer diameter (OD). Other than the dimensions there is no major difference between the two.
In order to find total heat loss through the pipes it is imperative to know the thermal conductivity and the differing thicknesses of each layer. The ground that surrounds the pipe also acts as a layer of insulation. Considering this, the thermal properties of the stoneless sand is included in the heat loss calculation.