Basic AC Source (Single Coil AC Generator)

The principle around AC generation is simple. If a magnetic field or magnet is rotated along a stationary set of coils (wires) or the rotation of a coil around a stationary magnetic field, an Alternating current is generated using an AC generator(Alternator).

The simplest form of AC generator consists of a loop of wire that is mechanically rotated about an axis while positioned between the north and south poles of a magnet.

Consider the Image below.

As the armature coil rotates within the magnetic field created by the north and south pole magnets, the magnetic flux through the coil changes, and charges are thus forced through the wire, giving rise to an effective voltage or induced voltage. The magnetic flux through the loop is as a result of the angle of the loop relative to the direction of the magnetic field.  Consider the images below;

From the images shown above, we can deduce that, certain number of magnetic field lines will be cut as the armature rotates, the amount of ‘lines cut’ determines the voltage output. With each change in the angle of rotation and the resultant circular motion of the armature against the magnetic lines, the amount of ‘magnetic lines cut’ also changes, hence the output voltage also change. For instance, the magnetic field lines cut at zero degree is zero which makes the resultant voltage zero, but at 90 degrees, almost all the magnetic field lines are cut, thus maximum voltage in one direction is generated in one direction. The same holds at 270 degrees only that it’s generated in the opposite direction. There is thus a resultant change in the voltage as the armature rotates within the magnetic field leading to the formation of a sinusoidal waveform. The resultant induced voltage is thus sinusoidal, with an angular frequency ω measured in radians per seconds.

The Induced current in the setup above is giving by the equation:

I = V/R

Where V= NABwsin(wt)

Where N = Speed

             A = Area

             B = Magnetic field

             w = Angular frequency.

Real AC generators are obviously more complex than this but they work based on the same principles and laws of electromagnetic induction as described above. Alternating current is also generated using certain kind of transducers and oscillator circuits as found in inverters.

Transformers

The induction principles on which AC is based is not limited to its generation only but also in its transmission and distribution. As at the time when AC came into reckoning, one of the main issues was the fact that DC couldn’t be transmitted over a long distance, thus one of the main issues, AC had to be solved to become viable, was to be able to safely deliver the high voltages (KVs) generated to consumers who use a voltages in the V range and not KV.  This is one of the reasons why the transformer is described as one of the major enablers of AC and its important to talk about it.

Transformer operation

In transformers, two coils are wired in such a way that when an Alternating current is applied in one, it induces voltage in the other. Transformers are devices which are used to either step down or step up voltage applied at one end (Primary Coil) to produce a lower or higher voltage respectively at the other end (Secondary Coil) of the transformer.  The Induced voltage in the secondary coil is always equal to the voltage applied at the primary multiplied by the ratio of the number of turns on the secondary coil to the primary coil.

A transformer being a step down or step up transformer is thus dependent on the ratio of number of turns on the secondary coil to the number of turns of conductor on the primary coil. If there are more turns on the primary coil compared to the secondary, the transformer steps down the voltage but if the primary coil has less number of turns compared to the secondary coil, the transformer steps up the voltage applied at the primary.

Transformers has made the distribution of electric power over long range very possible, cost-effective and practical. To reduce losses during transmission, electric power is transmitted from generating stations at high voltage and low current and are then distributed to homes and offices at low voltages and high currents with the aid of transformers.

So we will stop here so as not to overload the article with too much information. In part two of this article, we will be discussing AC waveforms and get into some equations and calculations. Stay tuned.